I have bought a new fan (Corsair SP120 Quiet at 1450 rpm) to replace a slightly broken, but very loud and clicking fan in a push and pull configuration on my Cooler Master Hyper 212X. My question is, taking into consideration that now I am using two different fans, the Corsair and one of the original Cooler Master fan (I think the rpm is around 2000 or more, I think).
Which one in your opinion should be the push and which one the pull?
Should I plug them both into the same mobo power connctor (CPU Fan), and if so, using a splitter connector, one end with 4 and the other with 3 pins, which one should be plugged into the 4 pins?
Would it be better to plugged them into two separate fan headers?
Thanks
New fan for push and pull configuration
-
- Newly registered user
- Posts: 1
- Joined: Tue Aug 26, 2003 10:31 am
Re: New fan for push and pull configuration
does your mobo have pins for controlling fans ? thats where they should go
- raffe
- Donator
- Posts: 2750
- Joined: Mon Dec 22, 2008 7:47 am
- Has thanked: 168 times
- Been thanked: 66 times
Re: New fan for push and pull configuration
The fan that moves most air should pull out the air. And like KingJohn say, best is in separate fan pins on the mobo.
Re: New fan for push and pull configuration
What do you mean? My mobo has 4 fan headers but I don't understand what you mean by "controlling fans"KingJohn wrote:does your mobo have pins for controlling fans ? thats where they should go
Re: New fan for push and pull configuration
Would it be bad to connect the two different fans to the same fan header?
- raffe
- Donator
- Posts: 2750
- Joined: Mon Dec 22, 2008 7:47 am
- Has thanked: 168 times
- Been thanked: 66 times
Re: New fan for push and pull configuration
I think KingJohn means that you should connect the fan's connectors into their own 3-pin or 4-pin fan header on your motherboard, IF you have two or more pins on the motherboard for fans, like this:

If you use the 4-pin fan header on your motherboard the fans will be regulated by the motherboard according to the temperature. If its cold the fan goes slow and if its warm the fan goes fast.
Every pin can on better mobos handle maybe up to 2A (24W), budget ones maybe 1A (12W).
If you only have one pin fan header on the motherboard:

If you use the 4-pin fan header on your motherboard the fans will be regulated by the motherboard according to the temperature. If its cold the fan goes slow and if its warm the fan goes fast.
Every pin can on better mobos handle maybe up to 2A (24W), budget ones maybe 1A (12W).
If you only have one pin fan header on the motherboard:
- The http://www.corsair.com/en-us/air-series ... -twin-pack say 0.18A
0.18 x 12 = 2,16W - The http://www.coolermaster.com/cooling/cpu ... yper-212x/ say 0.37A.
0.37 x 12 = 4,44W - So, a total of 0.55A = 0.55 x 12 = 6.6W
- 3 pin = Corsair say "Motherboard with an open standard 3-pin fan connector".
==> Note: when using a 3-pin power connector with a 4-pin fan header, the fan will always be on; there is no fan control.
. - 4 pin = Coolermaster say "Connector 4-Pin"